We are getting near the end, the next thing that we are going to be doing is creating a rectangle to act as the keyboard. I'll let you do this one, I'll only tell you that the size is H: 153 by W: 7 and it goes at the bottom of the CPU (overlapping the bottom). TIP: You can refer back to the introduction if you are confused on what anything should look like. You will also be creating the mouse (the last piece of the computer!!!!). I will provide you with a picture of the mouse and these hints: The "cord" was created using the pencil tool, it is not important where you connect it to the CPU. The mouse is an ellipse and the buttons were made using the line tool. Here is the picture that I promised:
Good luck! Move on to chapter 02 when you are done (click the next button).. |
\
|
|
|
 |
